Had a bit of time today to make some headway with the plates for the frame and the middle ring. Getting the hang of the router! Only issue i had preparing to route the bottom plate, my drill hole for the router to pivot round was slightly off centre. 1or 2mm. To correct it i didn't route the whole thing at once and did it in 2 halves so i could find the point where my bit might stray and correct the cut. Worked great. For some reason, lining up my angles on the ring and bottom plate, some are slightly off. Strange as i measured a few times to ensure it was correct. I'll be making sure all is above board when i cut the top plate tomorrow.
No comments:
Post a Comment